5_Light Installation REVISED

default

markdown

![](media/image1.png){width="1.3534722222222222in"
height="1.3131944444444446in"}**[\
\
]{.underline}**

![A close-up of a tape measure and a rectangular light bar Description
automatically generated](media/image2.png){width="3.2784722222222222in"
height="1.726388888888889in"}**[\
Installing Lights]{.underline}**

Light Bar Installation:

The RGB light bars should be placed on each side of your bimini\
or salon top (port and starboard) facing downward & outboard

so that the deck is illuminated by the RGB light bar with any additional
light\
spilling over into the water.

![A white boat on water at night Description automatically
generated](media/image3.jpeg){width="5.770833333333333in"
height="3.245138888888889in"}

Locate the 14AWG/ 3 conduit wire coming from the control box labeled
"RGB Light Bar":

**[If you are [using]{.underline} the provided DT style waterproof
connector]{.mark}**, use the following wiring diagram:

**[14 AWG / 3 Conduit]{.underline}** **[DT Connector]{.underline}**

WHITE Wire = (White Flood Light Power) = WHITE Wire

![](media/image4.png){width="3.0658891076115484in"
height="1.7586275153105861in"}GREEN Wire = (RGB Light Power) = RED Wire

BLACK Wire = Ground for Light (-) = Black Wire

*Pirate Lights Marine Security \| **Installing Lights** page 1 of 2*

[**If you are [removing]{.underline} the DT** **style waterproof
connector**]{.mark} from the light and wiring it directly, use the
following wiring diagram:

**[14 AWG / 3 Conduit]{.underline}** **[Wire directly from
light]{.underline}**

Black Wire = White Flood Lights\
White Wire -- RGB Lights

Red Wire -- Ground (-)

WHITE Wire = (White Flood Light Power) = BLACK Wire

![](media/image7.png){width="1.9666666666666666in"
height="3.227777777777778in"}GREEN Wire = (RGB Light Power) = WHITE Wire

BLACK Wire = Ground for Light (-) = RED Wire

**[[Cut wire From 12" Lights]{.underline}]{.smallcaps}**

![A close-up of a white object Description automatically
generated](media/image8.png){width="2.5875in"
height="1.0597222222222222in"}

**Strobing "Blind Light"**

Ideally, the "blind light" will be mounted over the companionway as it's
purpose is to stun "would be intruders" and reduce their ability to see
into the boat WHILE still allowing you to see them.

![](media/image9.png){width="2.675in" height="1.1666666666666667in"}

Locate the bundle of wires labeled "Blind Light" coming from the control
box and wire according to the following wiring diagram:

**["Blind Light" Wire Bundle]{.underline}** **[BLIND
LIGHT]{.underline}**

YELLOW Wire = (Power) = RED Wire

BLACK Wire = Ground for Light (-) = Black Wire

![](media/image10.png){width="6.5in" height="1.8409722222222222in"}

*Pirate Lights Marine Security \| **Installing Lights** page 2 of 2*

Uploading file...

Edit message:

Cancel

Editing 5_Light Installation REVISED